MA500+ Power and Network Cable Connection

 
In order to connect the power and network cables, follow the steps below:
 
Step 1: Disconnect the ribbon cable between the motherboard and the terminal block board so that the assembly shown above can be detached from the rest of the terminal.
Step 2: Pass the connecting cables through the cable entry.
Step 3: Connect cables to terminal blocks with adequate torque conformed to screw dimensions (see the detailed instructions in MA500 Series Installation Guide). Be sure during manipulation that the power supply from the electrical source is off.
 
MA500+ Power and Network Cable Connection
MA500+ terminal power and network connection
1

Power supply source

 
 
Block 1
+12V
In
Positive 12 Volts, power supply
Block 2
GND/ALIM
In
Ground power supply
 
Ground
In
Ground security reference
 
External power supply:
 
  • Must conform to CEE/EEC EN60950 standard
  • 9V to 16 Volts ± 5% (regulated) 1.5 Amp minimum (peak)
  • Power may come from a 12Volt Wiegand power supply, conforming to the Security Industry Association's Wiegand standard March 1995, able to deliver 9 Watts.
  • In standard operating activity, typical power consumption is 4.5 Watts.
  • In extreme temperature conditions, with all options (USB Flash drive, 12V output for Wiegand in), maximum power consumption is up to 9 Watts.
 
These terminals make use of POE functionality; if Ethernet network is POE compatible, power supply may come from Ethernet wiring.
2

Cable entry

 
 
Pass the connecting cables through the cable entry.
3

Ethernet

 
 
RJ 45 cabling connection